Search found 43 matches
- Tue Aug 02, 2016 3:02 pm
- Forum: FAQ about Tulipp Development Platform
- Topic: Programming the EMC2 board
- Replies: 12
- Views: 59030
Re: Programming the EMC2 board
Hi Francois, 1-Which Trenz module are you using on the EMC2 carrier board? Have you selected the right FPGA part in Vivado? 2-Which voltages have you selected through the jumpers? Are you able to measure them to check they are fine? 3-Is the Reset jumper (JP2) open? Otherwise the board is held in re...
- Thu Jun 30, 2016 10:17 am
- Forum: FAQ about Tulipp Development Platform
- Topic: Software JTAG Probe for Xilinz Zynq SoC
- Replies: 5
- Views: 6715
Re: Software JTAG Probe for Xilinz Zynq SoC
Hi again, Maybe you find this useful: https://forums.xilinx.com/t5/Zynq-All-Programmable-SoC/JTAG-for-ZYNQ/td-p/399745 As one of the users in that thread says, read the chapter 27 of the Zynq document http://www.xilinx.com/support/documentation/user_guides/ug585-Zynq-7000-TRM.pdf I hope that's helpf...
- Thu Jun 30, 2016 10:07 am
- Forum: FAQ about Tulipp Development Platform
- Topic: Software JTAG Probe for Xilinz Zynq SoC
- Replies: 5
- Views: 6715
Re: Software JTAG Probe for Xilinz Zynq SoC
Hi,
What we've always used is Uart. Use Uart0 in MIO pins 14-15, you can "activate" them in the Zynq processor system IP block in IP Integrator, in "MIO Configuration"
I will have a look for JTAG.
Regards,
Timoteo
What we've always used is Uart. Use Uart0 in MIO pins 14-15, you can "activate" them in the Zynq processor system IP block in IP Integrator, in "MIO Configuration"
I will have a look for JTAG.
Regards,
Timoteo