Page 2 of 2

Re: No results shown on the power measurement

Posted: Wed Nov 28, 2018 12:03 pm
by Asbjørn_Djupdal
Your lynsyn is not calibrated correctly. The analysis tool refuses to work when it sees calibration values that are highly unlikely to be correct.

Re: No results shown on the power measurement

Posted: Wed Nov 28, 2018 12:06 pm
by Asbjørn_Djupdal
Can you try another lynsyn board? or try to recalibrate this one? I do not know what causes this problem, it would be interesting to know so if recalibrating it does not work I would like to investigate further.

Re: No results shown on the power measurement

Posted: Thu Nov 29, 2018 11:19 pm
by Flemming_Christensen
Asbjørn_Djupdal wrote:Can you try another lynsyn board? or try to recalibrate this one? I do not know what causes this problem, it would be interesting to know so if recalibrating it does not work I would like to investigate further.


Hi,

This LynSyn was taken from 'tested-stock', but something could have happened. We could try a another from 'tested-stock' - or we could wait for the next firmware release to support update by USB.

What do you suggest?

FC

Re: No results shown on the power measurement

Posted: Fri Nov 30, 2018 7:57 am
by Asbjørn_Djupdal
I have tried the ones you sent us, they work correctly. Try another one, hopefully that works. If not, there must be a bug somewhere.

The USB fw update version is ready, we are just testing it here for a while to be sure it really works.