Hope you are doing fine.
Please share your experience in measuring power consumption of the EMC2 DP board.
I would like to understand if there are methods to measure power consumption at a higher granularity
than the wall-socket. For example, PS, PL, DRAM power.
I was looking at power measurement features on the ZC702 board. They have a TI power controller on board which provides power measurement API over the I2C bus.
http://www.wiki.xilinx.com/Zynq-7000+AP ... n+Tech+Tip
Are there similar power controllers on the EMC2 board? If not, are there shunt resistors?
Available to be read by all.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest