Power measurement on the EMC2 DP board

Available to be read by all.
Ananya.Muddukrishna
Posts: 40
Joined: Thu Jun 09, 2016 4:26 pm
Location: NTNU, Trondheim

Power measurement on the EMC2 DP board

Postby Ananya.Muddukrishna » Mon Dec 12, 2016 9:18 am

Hi Timoteo,

Hope you are doing fine.

Please share your experience in measuring power consumption of the EMC2 DP board.
I would like to understand if there are methods to measure power consumption at a higher granularity
than the wall-socket. For example, PS, PL, DRAM power.

I was looking at power measurement features on the ZC702 board. They have a TI power controller on board which provides power measurement API over the I2C bus.

http://www.wiki.xilinx.com/Zynq-7000+AP ... n+Tech+Tip

Are there similar power controllers on the EMC2 board? If not, are there shunt resistors?

Best regards,
Ananya
-----

Ananya Muddukrishna
Post-doctoral Research Fellow
Norwegian University of Science and Technology
https://www.ntnu.edu/employees/ananyam

Return to “FAQ about Tulipp Development Platform”

Who is online

Users browsing this forum: No registered users and 3 guests