Pitch of EMC2 LVTTL IO port connector

Available to be read by all.
Ananya.Muddukrishna
Posts: 40
Joined: Thu Jun 09, 2016 4:26 pm
Location: NTNU, Trondheim

Pitch of EMC2 LVTTL IO port connector

Postby Ananya.Muddukrishna » Fri Jul 07, 2017 11:13 am

Hi,

What is the pitch of the connector for the LVTTL IO port?

General purpose jumper wires designed for 2.54 mm pitch dont hold onto the LVTTL port strongly.

Best regards,
Ananya
-----

Ananya Muddukrishna
Post-doctoral Research Fellow
Norwegian University of Science and Technology
https://www.ntnu.edu/employees/ananyam

User avatar
Timoteo
Posts: 130
Joined: Thu Jun 09, 2016 11:47 am

Re: Pitch of EMC2 LVTTL IO port connector

Postby Timoteo » Fri Jul 07, 2017 12:02 pm

Hi Ananya,

Same measures than JTAG.

Page 9 you can see the exact numbers
https://www.xilinx.com/support/documentation/data_sheets/ds300.pdf

Timoteo

User avatar
Chris_Hamblin
Posts: 4
Joined: Tue May 10, 2016 1:30 pm

Re: Pitch of EMC2 LVTTL IO port connector

Postby Chris_Hamblin » Fri Jul 07, 2017 12:08 pm

The header on the board is 2mm pitch, not 0.1” (Or 2.54mm) which is why the “Standard 2.54mm” wires wouldn’t fit properly.

Depending what is needed to do, there are wires out there that go from 2mm to 0.1”:
https://www.amazon.co.uk/d/c7h/sourcing ... Y0PTFEEA9Y
(for example)

I’m sure that there are also wires cheaply available that just have 2mm crimps (in some form of housing) on one end.

Sundance would be able to make up any cable required, but the cost would be significantly higher than the above cables.

Ananya.Muddukrishna
Posts: 40
Joined: Thu Jun 09, 2016 4:26 pm
Location: NTNU, Trondheim

Re: Pitch of EMC2 LVTTL IO port connector

Postby Ananya.Muddukrishna » Tue Jul 11, 2017 10:44 am

Excellent information. Thanks!

I will get those 2-2.54 converter wires.

Note to myself: Never spend half-an-hour of precious life trying to force squeeze 2.54 mm crimps to 2 mm. :D
-----

Ananya Muddukrishna
Post-doctoral Research Fellow
Norwegian University of Science and Technology
https://www.ntnu.edu/employees/ananyam


Return to “FAQ about Tulipp Development Platform”

Who is online

Users browsing this forum: No registered users and 1 guest