Power measurement on the EMC2 DP board
Posted: Mon Dec 12, 2016 9:18 am
Hi Timoteo,
Hope you are doing fine.
Please share your experience in measuring power consumption of the EMC2 DP board.
I would like to understand if there are methods to measure power consumption at a higher granularity
than the wall-socket. For example, PS, PL, DRAM power.
I was looking at power measurement features on the ZC702 board. They have a TI power controller on board which provides power measurement API over the I2C bus.
http://www.wiki.xilinx.com/Zynq-7000+AP ... n+Tech+Tip
Are there similar power controllers on the EMC2 board? If not, are there shunt resistors?
Best regards,
Ananya
Hope you are doing fine.
Please share your experience in measuring power consumption of the EMC2 DP board.
I would like to understand if there are methods to measure power consumption at a higher granularity
than the wall-socket. For example, PS, PL, DRAM power.
I was looking at power measurement features on the ZC702 board. They have a TI power controller on board which provides power measurement API over the I2C bus.
http://www.wiki.xilinx.com/Zynq-7000+AP ... n+Tech+Tip
Are there similar power controllers on the EMC2 board? If not, are there shunt resistors?
Best regards,
Ananya